FAQ – UltiMachine
FAQ
ELECTRONICS
RAMBo 1.3
http://reprap.org/wiki/Rambo_v1.3#Troubleshooting
Mini-Rambo
http://reprap.org/wiki/MiniRambo#Troubleshooting
Firmware
Q.) Print from SD is missing from the LCD menu.
A.) In MarlinFirmware file Configuration.h uncomment "#define SDSUPPORT" by removing the first two slashes.
Power Supply
http://reprap.org/wiki/Power_Supply
FILAMENT
Q.) What are the spool dimensions?
A.) 1KG (2.2lb)Spool Dimensions
- OD: 8" (203.20mm)
- ID: 2" (50.80mm)
- OD width: 2-7/8" (73.025mm)
- ID width: 2-2/8" (57.15mm)
5LB (2.3kg)Spool Dimensions
- OD: 10.5" (266.70mm)
- ID: 1.5" (38.10mm)
- W: 4" (101.6mm)
----------------------------------------------------------------------------------------------
Q.) Can you please provide the technical or safety data sheets for your filament?
Polycarbonate Safety Data Sheet
HIPS Material Safety Data Sheet
PVA Material Safety Data Sheet
----------------------------------------------------------------------------------------------
Q.) How do you calculate material cost of a print.
shop.app
shop.app is blocked
This page has been blocked by an extension
- Try disabling your extensions.
ERR_BLOCKED_BY_CLIENT
Reload
This page has been blocked by an extension
ultimachine.com
ultimachine.com is blocked
This page has been blocked by an extension
- Try disabling your extensions.
ERR_BLOCKED_BY_CLIENT
Reload
This page has been blocked by an extension
ultimachine.com
ultimachine.com is blocked
This page has been blocked by an extension
- Try disabling your extensions.
ERR_BLOCKED_BY_CLIENT
Reload
This page has been blocked by an extension